Allied Telesis AT-S63 - Manual (Page 582)

Chapter 23: Port-based and Tagged VLANs
582 Section V: VLANs
connecting the switches together are either tagged or untagged members
of the NMS VLAN. You also need to specify the NMS VLAN as the
management VLAN on each switch using the AT-S63 management
software. Finally, you must be sure to connect your management station
to a port on a switch that is a tagged or untagged member of the
management VLAN.
Note
You cannot specify a management VLAN when the switch is
operating in a multiple VLAN mode.
To specify a management VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 198 on page 561.
2. From the VLAN Configuration menu, type 3 to select Management
VLAN.
The following prompt is displayed:
Enter Management VLAN ID [1 to 4094] ->
3. Specify the VID of the VLAN that is to function as the management
VLAN. This VLAN must already exist on the switch.
The following prompt is displayed:
SUCCESS
Press any key to continue ...
4. Press any key.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.