Displaying the mstp port state – Allied Telesis AT-S63 User Manual
Page 540
Chapter 22: MSTP
540
Section IV: Spanning Tree Protocols
Displaying the MSTP Port State
To display the MSTP port state, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 169 on
page 485.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The MSTP menu is shown in Figure 186 on page 517.
3. From the MSTP menu, type P to select MSTP Port Parameters.
The MSTP Port Parameters menu is shown in Figure 190 on page
533.
4. From the MSTP Port Parameters menu, type 3 to select Display MSTP
Port State.
The following prompt is displayed:
Enter Spanning Tree (CIST/MSTI) ID to display port state:
[0 to 15} ->
5. Enter an MSTI ID.