Deleting an ace – Allied Telesis AT-S63 User Manual
Page 784
Chapter 35: Management Access Control Lists
784
Section VII: Management Security
Deleting an ACE
To delete an ACE, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 46.
2. From the System Administration menu, type 7 to select Management
ACL menu.
The Management ACL menu is shown in Figure 275 on page 780.
3. From the Management ACL menu, type 3 to select Delete
Management ACL Entry.
The following prompt is displayed:
Enter the IP Address:
4. Enter the IP address for the ACE you want to delete.
The AT-S63 management software prompts you to enter the specifics of
the ACE that you want to delete. (It can help to first display the contents of
the management ACL, using the procedure in ”Displaying the ACEs”, next,
and jot down on paper the IP address, mask, protocol, and Interface
information on the ACE you want to delete. In that way you will have the
information when the software prompts you for it.)