Allied Telesis AT-S63 - Manual (Page 233)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 233
6. To display events of a selected severity, type 5 to select Display
Severity.
The following prompt is displayed:
Enter Severity levels to display (ALL, E - Error, W -
Warning, I - Information, D - Debug) ->
The possible options are:
ALL
All messages of the following types are displayed. This is the default.
E - Error
Only error messages are displayed. Error messages indicate that the
switch operation is severely impaired.
W - Warning
Only warning messages are displayed. These messages indicate that
an issue may require manager attention.
I - Information
Only informational messages are displayed. Informational messages
display useful information that you can ignore during normal operation.
D - Debug
Debug messages provide detailed high-volume information that is
intended only for technical support personnel.
You can select more than one severity at a time, separated by a
comma, for example, E,W.
7. To display events of a particular AT-S63 software module, type 7 to
select Event Module.
The list of modules is displayed
8. Enter a list of modules separated by a comma—for example, “system,
stp, ptrunk.”
Table 2 shows the list of modules.
Table 2. AT-S63 Modules
Module Name Description
ALL All modules
ACL Port access control list
CFG Switch configuration
CLASSIFIER Classifiers used by ACL and QoS