Allied Telesis AT-S63 - Manual (Page 325)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 325
The Modify Traffic Class menu is shown in Figure 117.
Figure 117. Modify Traffic Class Menu
6. Modify the settings as needed. For parameter definitions, refer to
“Creating a Traffic Class” on page 320.
When you modify a traffic class, note the following:
ˆ You cannot change the traffic class ID number.
ˆ To delete a value from a variable so as to leave it blank, select the
variable and then use the backspace key to delete its default value.
ˆ Specifying an invalid value for a parameter that already has a value
causes the parameter to revert to its default value.
7. Type M to select Modify Traffic Class.
8. To modify another traffic class, repeat this procedure starting with step
4. To assign the traffic class to a policy, go to “Managing Policies” on
page 330.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting a Traffic
Class
To delete a traffic class, perform the following procedure:
1. From the Main Menu, type 7 to select Security and Services.
The Security and Services menu is shown in Figure 82 on page 259.
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Modify Traffic Class
1 - Traffic Class ID .......... 0
2 - Description ............... Video2
3 - Exceed Action ............. Drop
4 - Exceed Remark Value ....... 0
5 - DSCP value ................ 0
6 - Max bandwidth ............. 0
7 - Burst Size ................ 0
8 - Priority .................. 0
9 - Remark Priority ........... No
A - VLAN ID ................... 2
B - Flow Group List ........... 23
M - Modify Traffic Class
R - Return to Previous Menu
Enter your selection?