Allied Telesis AT-S63 - Manual (Page 449)

AT-S63 Management Software Menus Interface User’s Guide
Section III: SNMPv3 449
4. To change the Security Name parameter, type 1 to select Set Security
Name.
The following prompt is displayed:
Enter Target Parameters Name:
5. Enter a previously configured Target Parameters Name.
Enter a value of up to 32 alphanumeric characters.
The following prompt is displayed:
Enter User (Security) Name:
6. Enter a User Name.
Enter a value that you previously configured with the Configure
SNMPv3 User Table menu. You can enter a value of up to 32
alphanumeric characters.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying the Security Model
For the Security or User Name you have selected, the value of the
Security Model parameter in an SNMPv3 Target Parameter Table entry
must match the value of the Security Model parameter in the SNMPv3
Access Table entry.
Caution
If the values of the Security Model parameter in the SNMPv3 User
Table and the SNMPv3 Target Parameter Table entry do not match,
notification messages are not generated on behalf of this User
(Security) Name.
To modify the Security Model parameter in an SNMPv3 Target Parameter
Table entry, perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 380. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 139 on page
381.
2. From the Configure SNMPv3 Table menu, type 8 to select Configure
SNMPv3 Target Address Table.