Allied Telesis AT-S63 - Manual (Page 151)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Features 151
The LACP (IEEE 8023ad) Configuration menu is shown in Figure 41
on page 144.
4. Type 4 to select Modify Aggregator.
The Modify LACP (IEEE 8023ad) Aggregator menu is shown in Figure
44.
Figure 44. Modify LACP (IEEE 8023ad) Aggregator Menu
5. Type 1 to select Port Number and, when prompted, enter the port you
want to configure. You can configure only one port at a time.
The management software displays the port’s current aggregator
settings. If the port is not a member of any aggregator, the parameters
still display default values that are specific to the port and switch.
6. To set the port’s priority value, type 3 to Priority and enter the new
value in hexadecimal. The range is 1 to FFFF. The default is the port
number in hexadecimal.
7. To move the port to a different aggregator or to assign it to an
aggregator if it is not currently a member of one, type either 2 to select
Adminkey or 4 to select Aggregator and enter the adminkey value or
name of the aggregator where you want to assign the port. You can
specify only one aggregator and it must already exist on the switch.
8. Type M to select Modify Port.
Displaying LACP
Port or
Aggregator
Status
To display LACP port or aggregator status, perform the following
procedure:
1. From the Main Menu, type 1 to select Port Configuration.
The Port Configuration menu is shown in Figure 25 on page 102.
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
LACP (IEEE 802.3ad) Port Configuration
1 - Port Number ................. 0
2 - Adminkey .................... 0x0000
3 - Priority .................... 0x0000
4 - Aggregator ..................
M - Modify Port
R - Return to Previous Menu
Enter your selection?