Allied Telesis AT-S63 - Manual (Page 527)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: Spanning Tree Protocols 527
Adding, Removing, or Modifying VLAN Associations to MSTI IDs
When you create a new MSTI ID, you are given the opportunity of
associating VLANs to it. But after an MSTI ID is created, you may want to
add more VLANs to it, or perhaps remove VLANs. This procedure explains
how to associate VLANs on the switch to an existing MSTI ID and also
how to remove VLANs. Before performing this procedure, note the
following:
ˆ You must create a MSTI ID before you can assign VLANs to it. To
create a MSTI ID, refer to “Creating, Deleting, and Modifying MSTI
IDs” on page 524.
ˆ You can assign a VLAN to only one MSTI. By default, a VLAN, when
created, is associated with the CIST instance, which has a MSTI ID of
0.
ˆ An MSTI can contain any number of VLANs.
This section contains the following procedures:
ˆ ”Adding or Removing a VLAN from an MSTI ID” next
ˆ “Associating a VLAN to an MSTI ID” on page 528
ˆ “Removing a VLAN from an MSTI ID” on page 529
ˆ “Associating VLANs to an MSTI ID and Deleting All Associated
VLANs” on page 530
ˆ “Clearing VLAN to MSTI Associations” on page 531
Adding or
Removing a
VLAN from an
MSTI ID
To add or remove a VLAN from an MSTI ID, perform the following
procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 169 on
page 485.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The MSTP menu is shown in Figure 186 on page 517.
3. From the MSTP menu, type M to select MSTI menu.
The MSTI menu is shown in Figure 188 on page 522.
4. From the MSTP menu, type V to select VLAN-MSTI Association menu.