Allied Telesis AT-S63 - Manual (Page 150)

Chapter 7: Static and LACP Port Trunks
150 Section I: Basic Features
2. From the Port Configuration menu, type 4 to select Port Trunking and
LACP.
The Port Trunking and LACP menu is shown in Figure 37 on page 137.
3. Type 2 to select LACP Configuration.
The LACP (IEEE 8023ad) Configuration menu is shown in Figure 41
on page 144.
4. Type 6 to select Delete Aggregator.
The following prompt is displayed:
Enter Aggregator Name [Max up to 20 alphanumeric
characters]:
5. Enter the name of the aggregator you want to delete. The name is
case-sensitive. You can delete only one aggregator at a time.
Are you sure you want to delete this aggregator (Y/N) [Yes/No]
->
6. Type Y to delete the aggregator or N to cancel the procedure.
If you entered Yes, the aggregator is deleted.
Configuring
LACP Port
Parameters
This procedure explains how to configure a port’s priority value. This
parameter determines whether a port is active or in standby mode as part
of an aggregate trunk. For further information, refer to “LACP Port Priority
Parameter” on page 131. This procedure also shows how to assign a port
to a different aggregator.
Note
To remove a port from an aggregator without assigning it to a
different one, skip this procedure and instead perform “Modifying an
Aggregator” on page 147. When modifying the aggregator, reenter
its port list, omitting the port you want to remove.
To configure a port, perform the following procedure:
1. From the Main Menu, type 1 to select Port Configuration.
The Port Configuration menu is shown in Figure 25 on page 102.
2. From the Port Configuration menu, type 4 to select Port Trunking and
LACP.
The Port Trunking and LACP menu is shown in Figure 37 on page 137.
3. Type 2 to select LACP Configuration.