Allied Telesis AT-S63 - Manual (Page 642)

Chapter 27: Port Security
642 Section IV: Port Security
5. From the Configure Port Security menu, type 1 to select Security
Mode.
The following prompt is displayed:
Enter new mode (A-Automatic, L-Limited, S-Secured, K-
locKed):
6. Select the desired security level. For definitions of the security levels,
refer to “MAC Address Security Overview” on page 638.
If you select Automatic, which disables port security on the port, return
to the Main Menu to save your change.
If you selected Limited, several new menu options are added to the
Configure Port Security menu, as shown in Figure 231.
Figure 231. Configure Port Security Menu #2
Note
If you selected Limited, go to the next step. If you selected the
Secured or Locked mode, repeat this procedure to configure other
ports or go to step 10 to save your changes.
7. To set the intrusion action for the port, do the following:
a. Type 2 to select Intruder Action.
The following prompt is displayed:
Enter intrusion action: (N-No Action(Discard), T-Trap,
D-Disable):
b. Select the desired intrusion action:
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Configure Port Security
Configuring Port Security 4
1 - Security Mode ..................... Limited
2 - Intruder Action ................... No Action
3 - Port Participating ................ No
4 - Threshold ......................... 100
D - Set Default Port Security
R - Return to Previous Menu
Enter your selection?