Allied Telesis AT-S63 - Manual (Page 487)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: Spanning Tree Protocols 487
Configuring STP
This section contains the following procedures:
ˆ ”Configuring STP Bridge Settings”, next
ˆ “Configuring STP Port Settings” on page 489
Configuring STP
Bridge Settings
This section contains the procedure for configuring a bridge’s STP
settings.
Caution
The default STP parameters are adequate for most networks.
Changing them without prior experience and an understanding of
how STP works might have a negative effect on your network. You
should consult the IEEE 802.1d standard before changing any of the
STP parameters.
To configure the bridge settings, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 169 on
page 485.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The STP menu is shown in Figure 170.
Figure 170. STP Menu
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
STP Menu
1 - Bridge Priority ..... 32768
2 - Bridge Hello Time ... 2
3 - Bridge Forwarding ... 15
4 - Bridge Max Age ...... 20
5 - Bridge Identifier ... 00:30:84:00:00:00
P - STP Port Settings
D - Reset STP to Defaults
R - Return to Previous Menu
Enter your selection?