Allied Telesis AT-S63 - Manual (Page 67)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 67
Returning the AT-S63 Management Software to the Factory Default
Values
The procedure in this section returns all AT-S63 management software
parameters to the default values. Please note the following before you
perform this procedure:
ˆ Returning all parameter settings to their default values also deletes
any port-based or tagged VLANs you created on the switch.
ˆ This procedure does not delete files from the AT-S63 file system. To
delete files, refer to Chapter 10, ”File System” on page 179.
ˆ This procedure does not delete any encryption keys stored in the key
database. To delete encryption keys, refer to “Deleting an Encryption
Key” on page 709.
ˆ Returning a switch to its default values does not alter the contents of
the active boot configuration file. To reset the file back to the default
settings, you must reestablish your management session after the
switch reboots and then select Save Configuration changes. Otherwise
the switch reverts back to the previous configuration the next time you
reset the switch.
Note
The AT-S63 management software default values are listed in
Appendix 1, ”AT-S63 Default Settings” on page 1.
To return the AT-S63 management software to the default settings,
perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 46.
2. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 7 on page 53.
3. From the System Utilities menu, type 4 to select Reset to Factory
Defaults.
The following prompt is displayed:
Do you want to reset to factory defaults? [Yes/No] ->
4. Type Y for yes or N to cancel the procedure.
If you respond with yes, the following prompt is displayed: