Allied Telesis AT-S63 - Manual (Page 517)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: Spanning Tree Protocols 517
Configuring MSTP Bridge Settings
To configure a bridge’s MSTP settings, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 169 on
page 485.
2. From the Spanning Tree menu, type 3 to select Configure Active
Protocol.
The MSTP menu is shown in Figure 186.
Figure 186. MSTP Menu
3. Configure the following parameters as necessary.
1 - Force Version
This selection determines whether the bridge operates with MSTP or in
an STP-compatible mode. If you select MSTP, the bridge operates all
ports in MSTP, except for those ports that receive STP or RSTP BPDU
packets. If you select Force STP Compatible, the bridge uses its MSTP
parameter settings, but sends only STP BPDU packets from the ports.
2 - Hello Time
The time interval between generating and sending configuration
messages by the bridge. The range of this parameter is 1 to 10
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
MSTP Menu
1 - Force Version .......... MSTP
2 - Hello Time ............. 2
3 - Forwarding Delay ....... 15
4 - Max Age ................ 20
5 - Max Hops ............... 20
6 - Configuration Name .....
7 - Revision Level ......... 0
8 - Bridge Identifier ...... 00:30:24:1E:EE:11
9 - Root Identifier ........ 00:30:84:EF:CC:DD
C - CIST Menu
M - MSTI Menu
V - VLAN-MSTI Association Menu
P - MSTP Port Parameters
D - Reset MSTP to Defaults
R - Return to Previous Menu
Enter your selection?