Allied Telesis AT-S63 - Manual (Page 39)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 39
3. Configure the terminal or terminal emulation program as follows:
ˆ Baud rate: 9600 to 115200 bps
ˆ Data bits: 8
ˆ Parity: None
ˆ Stop bits: 1
ˆ Flow control: None
Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
4. Press Enter.
You are prompted for a user name and password.
5. To configure the switch settings, enter “manager” as the user name.
The default password for manager access is “friend.“To just view the
settings, enter “operator” as the user name. The default password for
operator access is “operator.” User names and passwords are case
sensitive. For information on the two access levels, refer to
“Management Access Levels” on page 33. (For instructions on how to
change a password, refer to “Working With the Manager and Operator
Passwords” on page 55.)
6. The local management session starts and the command line interface
(CLI) prompt is displayed, as shown in Figure 2.
Figure 2. CLI Prompt
If the switch has been configured with a name, the name is displayed
after the software version information and before the command
prompt.
For information about the command line interface, refer to the AT-S63
Management Software Command Line Interface User’s Guide.
7. To use the menus interface, type menu and press Return.
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
#