Resetting rstp to the default settings – Allied Telesis AT-S63 User Manual

Page 500

Advertising
background image

Chapter 21: STP and RSTP

500

Section IV: Spanning Tree Protocols

Disabled - The port has not established a link with its end node.

Role
The RSTP role of the port. Possible roles are:

Root - The port that is connected to the root switch, directly or through
other switches, with the least path cost.

Alternate - The port offers an alternate path in the direction of the root
switch.

Backup - The port on a designated switch that provides a backup for
the path provided by the designated port.

Designated - The port on the designated switch for a LAN that has the
least cost path to the root switch. This port connects the LAN to the
root switch.

P2P
Whether or not the port is functioning as a point-to-point port. The
possible settings are Yes, No, and Auto-Detect.

Version
Whether the port is operating in RSTP mode or STP-compatible mode.

Port Cost
The port cost of the port.

Resetting RSTP

to the Default

Settings

To reset RSTP to the default settings, perform the following procedure:

1. From the Main Menu, type 3 to select Spanning Tree Configuration.

The Spanning Tree Configuration menu is shown in Figure 169 on
page 485.

2. From the Spanning Tree Configuration menu, type 3 to select

Configure Active Protocol.

The RSTP menu is shown in Figure 174 on page 493.

3. From the RSTP Menu, type D to select Reset RSTP to Defaults.

The following prompt is displayed:

Do you want to reset RSTP configuration to default [Yes/
No] ->

4. Type Y for Yes or N for No and press Return.

The RSTP configuration is reset to the defaults.

Advertising