Allied Telesis AT-S63 - Manual (Page 660)

Chapter 28: 802.1x Port-based Network Access Control
660 Section IV: Port Security
Configuring Authenticator Port Parameters
To configure authenticator port parameters, perform the following
procedure:
1. From the Main Menu, type 7 to select Security and Services.
The Security and Services menu is shown in Figure 82 on page 259.
2. From the Security Configuration menu, type 1 to select Port Access
Control (802.1X).
The Port Access Control (802.1X) menu is shown in Figure 236 on
page 657.
3. From the Port Access Control menu, type 4 to select Configure
Authenticator.
The Configure Authenticator menu is shown in Figure 238.
Figure 238. Configure Authenticator Menu
4. From the Configure Authenticator menu, type 1 to select Configure
Authenticator Port Access Parameters.
The following prompt is displayed:
Enter port list ->
5. Enter the authenticator port number whose parameters you want to
change. You can specify one port or a range of ports (for example, 4-
8), but not nonconsecutive ports (for example, 4,6,11).
Note
A port must already be configured as an authenticator before you
can configure its settings. For instructions on how to change the role
of a port, refer to “Setting Port Roles” on page 657.
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Configure Authenticator
1 - Configure Authenticator Port Access Parameters
2 - Display Authenticator Port Access Parameters
R - Return to Previous Menu
Enter your selection?