Allied Telesis AT-S63 - Manual (Page 248)

Chapter 12: Event Log
248 Section II: Advanced Operations
Enter output ID to modify [0 to 20] ->
5. Enter the number of the log output that you want to modify.
The Syslog Output Configuration menu is displayed, as shown in
Figure 77 on page 243.
6. Refer to “Creating a Log Output Definition” on page 241 for information
about the output selections.
7. When you complete the modifications, type M to select Modify Log
Output.
The Configure Log Outputs menu as shown in Figure 76 on page 242
is redisplayed.
8. Return to the Main Menu.
Deleting a Log
Output
To delete a log output definition you have already created, perform the
following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 46.
2. From the System Administration menu, type 8 to select Event Log.
The Event Log menu is shown in Figure 72 on page 231.
3. From the Event Log menu, type L to select Configure Log Outputs.
The Configure Log Outputs menu is shown in Figure 76 on page 242.
4. From the Configure Log Outputs menu, type 3 to select Modify Log
Output.
The following prompt is displayed:
Enter output ID to delete [0 to 20] ->
5. Enter the number of the log output that you want to delete.
The following prompt is displayed:
Are you sure you want to delete output ID x? [Yes/No] ->
6. Enter Y for Yes or N for No and press Enter.
If you enter Y, the output ID you selected is deleted.
7. Return to the Main Menu.