Allied Telesis AT-S63 - Manual (Page 452)

Chapter 20: SNMPv3
452 Section III: SNMPv3
A-AuthNoPriv
This option represents authentication, but no privacy protocol. Select
this security level if you want to authenticate SNMP users, but you do
not want to encrypt messages using a privacy protocol.You can select
this value if you configured the Security Model parameter with the
SNMPv3 protocol.
P-AuthPriv
This option represents authentication and the privacy protocol. Select
this security level to encrypt messages using a privacy protocol and
authenticate SNMP entities. This level provides the greatest level of
security. You can select this value if you configured the Security Model
parameter with the SNMPv3 protocol.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying the Message Process Model
You can modify the Message Process Model for SNMPv1 and SNMPv2c
protocol configurations only. When you configure the SNMPv3 protocol,
the Message Process Model is automatically assigned to the SNMPv3
protocol.
To modify the Message Process Model parameter in an SNMPv3 Target
Parameter Table entry, perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 380. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 139 on page
381.
2. From the Configure SNMPv3 Table menu, type 8 to select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Parameters Table menu is shown in
Figure 152.
3. From the Configure SNMPv3 Target Parameters Table menu, type 3 to
select Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Parameters Table menu is shown in
Figure 153 on page 448.
4. To modify the Message Process Model, type 4 to select Set Message
Processing Model.
The following prompt is displayed:
Enter Target Parameters Name: