Allied Telesis AT-S63 - Manual (Page 321)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 321
The Create Traffic Class menu is shown in Figure 116.
Figure 116. Create Traffic Class Menu
5. Configure the following parameters as desired:
1 - Traffic Class ID
Specifies an ID number for the traffic class. Each traffic class on the
switch must be assigned a unique number. The range is 0 to 511. The
default is 0. This parameter is required.
2 - Description
Specifies a description for the traffic class. The description can be from
1 to 15 alphanumeric characters. Spaces are allowed. This parameter
is optional, but recommended. Names can help you identify the traffic
classes on the switch.
3 - Exceed Action
Specifies the action to be taken if the traffic of the traffic class exceeds
the maximum bandwidth, specified in option 6. There are two possible
exceed actions, drop and remark. If drop is selected, traffic exceeding
the bandwidth is discarded. If remark is selected, the packets are
forwarded after replacing the DSCP value with the new value specified
in option 4, Exceed Remark Value. The default is drop.
4 - Exceed Remark Value
Specifies the DSCP replacement value for traffic that exceeds the
maximum bandwidth. This value takes precedence over the DSCP
value set with option 5, DSCP Value. The default is 0.
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Create Traffic Class
1 - Traffic Class ID ..........
2 - Description ...............
3 - Exceed Action .............
4 - Exceed Remark Value .......
5 - DSCP value ................
6 - Max bandwidth .............
7 - Burst Size ................
8 - Priority ..................
9 - Remark Priority ...........
A- Flow Group List ...........
C - Create Traffic Class
R - Return to Previous Menu
Enter your selection?