Allied Telesis AT-S63 - Manual (Page 465)

AT-S63 Management Software Menus Interface User’s Guide
Section III: SNMPv3 465
Displaying SNMPv3 Table Menus
The procedures in this section describe how to display the SNMPv3
Tables. The following procedures are provided:
ˆ “Displaying the Display SNMPv3 User Table Menu,” next
ˆ “Displaying the Display SNMPv3 View Table Menu” on page 466
ˆ “Displaying the Display SNMPv3 Access Table Menu” on page 467
ˆ “Displaying the Display SNMPv3 SecurityToGroup Table Menu” on
page 468
ˆ “Displaying the Display SNMPv3 Notify Table Menu” on page 469
ˆ “Displaying the Display SNMPv3 Target Address Table Menu” on
page 470
ˆ “Displaying the Display SNMPv3 Target Parameters Table Menu” on
page 470
ˆ “Displaying the Display SNMPv3 Community Table Menu” on page 471
Displaying the
Display SNMPv3
User Table Menu
This section describes how to display the Display SNMPv3 User Table
menu. For information about the SNMPv3 User Table, see “Creating an
SNMPv3 User Table Entry” on page 380.
To display the Display SNMPv3 User Table menu, perform the following
procedure.
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 7 on page 53.
2. From the System Administration menu, type 5 to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 16 on page 79.
3. From the SNMP Configuration menu, type 6 to select Display SNMPv3
Table.