Allied Telesis AT-S63 - Manual (Page 331)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 331
The Create Policy menu is shown in Figure 122.
Figure 122. Create Policy Menu
5. Configure the following parameters as needed:
1 - Policy ID
Specifies an ID number for the policy. Each policy on the switch must
be assigned a unique number. The range is 0 to 255. The default is 0.
This parameter is required.
2 - Description
Specifies a description for the policy. The description can be from 1 to
15 alphanumeric characters. Spaces are allowed. This parameter is
optional, but recommended. Names can help you identify the policies
on the switch.
3- Remark DSCP
Specifies the conditions under which the ingress DSCP value is
overwritten. If All is specified, all packets are remarked. If None is
specified, the function is disabled. The default is None.
4 - DSCP value
Specifies a replacement value to write into the DSCP (TOS) field of the
packets. The range is 0 to 63.
A new DSCP value can be set at all three levels: flow group, traffic
class, and policy. A DSCP value specified in a flow group overrides a
DSCP value specified at the traffic class or policy level. A DSCP value
specified at the policy level is used only if no value has been specified
at the flow group and traffic class levels.
5 - Traffic Class List
Specifies the traffic classes to be assigned to the policy. The specified
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Create Policy
1 - Policy ID ............
2 - Description ..........
3 - Remark DSCP ..........
4 - DSCP value ...........
5 - Traffic Class List ...
6 - Redirect Port ........
7 - Ingress Port List ....
8 - Egress Port ..........
C - Create Policy
R - Return to Previous Menu
Enter your selection?