Allied Telesis AT-S63 - Manual (Page 450)

Chapter 20: SNMPv3
450 Section III: SNMPv3
The Configure SNMPv3 Target Parameters Table menu is shown in
Figure 152.
3. From the Configure SNMPv3 Target Parameters Table menu, type 3 to
select Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Parameters Table menu is shown in
Figure 153 on page 448.
4. To change the Security Model, type 2 to select Security Model.
The following prompt is displayed:
Enter Target Parameters Name:
5. Enter a previously configured Target Parameters Name.
Enter a value of up to 32 alphanumeric characters.
The following prompt is displayed:
Enter Security Model [1-v1, 2-v2c, 3-v3]:
6. Select one of the following SNMP protocols that was previously
configured as the Security Model for this Security Name, or User Name.
1-v1
Select this value if this User Name is associated with the SNMPv1
protocol.
2-v2c
Select this value if this User Name is associated with the SNMPv2c
protocol.
3-v3
Select this value if this User Name is associated with the SNMPv3
protocol.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying the Security Level
For the Security or User Name you have selected, the value of the
Security Level parameter in an SNMPv3 Target Parameter Table entry
must match the value of the Security Level parameter in the SNMPv3 User
Table entry.
To modify the Security Level parameter in an SNMPv3 Target Parameter
Table entry, perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 380. Or, from the Main Menu type