Allied Telesis AT-S63 - Manual (Page 345)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 345
5. Type 2 to select Priority (0 - 7). The following prompt is displayed:
Enter new value -> [0 to 7]
6. Enter a value from 1 to 7 that corresponds to the egress queue where
you want all untagged frames received on the port to be stored. For
example, if you want all ingress untagged packets received on the port
stored in egress queue Q2, enter 4 or 5. The default is 0, which
corresponds to Q0. (If you perform Step 6 and override the priority
level in tagged packets, this queue will also be used to store all tagged
packets.) The default values are listed in Table 6.
7. If you are configuring a tagged port and you want the switch to ignore
the priority tag in ingress tagged frames, type 3 to select Override
Priority and type Y.
All ingress tagged frames are directed to the queue specified in Step 6.
Note
The tagged information in a frame is not changed as the frame
traverses the switch. A tagged frame leaves a switch with the same
priority level that it had when it entered.
The default for this parameter is No, meaning that the priority level of
tagged frames is determined by the priority level specified in the frame
itself.
8. Type C to select Configure Port COS Priorities.
A change to a port CoS setting is immediately activated on the port.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.