Allied Telesis AT-S63 - Manual (Page 519)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: Spanning Tree Protocols 519
9 - Root Identifier
If this MAC address is the same as the bridge’s MAC address, then the
switch is also functioning as a root bridge. If the two MAC addresses
are different, then a different switch is functioning as the root bridge.
You cannot change this parameter. This parameter is only displayed
with MSTP is enabled.
Note
Selection C, CIST menu, is described in “Configuring the CIST
Priority,” next.
Selection M, MSTI menu, is described in “Creating, Deleting, and
Modifying MSTI IDs” on page 524.
Selection V, VLAN-MSTI Association menu, is described in “Adding,
Removing, or Modifying VLAN Associations to MSTI IDs” on
page 527.
Selection P, MSTP Port Parameters, is described in “Configuring
MSTP Port Settings” on page 532.
Selection D, Reset MSTP to Defaults, is described in “Resetting
MSTP to the Defaults” on page 543.
4. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.