Allied Telesis AT-S63 - Manual (Page 146)

Chapter 7: Static and LACP Port Trunks
146 Section I: Basic Features
The Create LACP (IEEE 8023ad) Aggregator menu is shown in Figure
42.
Figure 42. Create LACP (IEEE 8023ad) Aggregator Menu
5. Configure the following parameters as necessary:
1 - Aggregator
Specifies a name for the aggregator. The name can be up to 20
alphanumeric characters. Spaces are allowed, but special characters,
such as asterisks and exclamation points, are not. Each aggregator
must have a unique name.
2 - Adminkey
Specifies a unique adminkey value for the aggregator. The value is
entered in hexadecimal. The range is 1 to FFFF. For background
information, refer to “Adminkey Parameter” on page 131.
3 - Distribution Mode
Sets the load distribution method. Possible settings are:
ˆ SRC MAC - Source MAC address
ˆ DST MAC - Destination MAC address
ˆ SRC/DST MAC - Source address /destination MAC address
ˆ SRC IP - Source IP address trunking
ˆ DST IP - Destination IP address trunking
ˆ SRC/DST IP - Source address /destination IP address
The default is SRC/DST MAC. For background information, refer to
“Load Distribution Methods” on page 134.
4 - Port Range
Specifies the aggregator ports. An aggregator can contain any number
of ports on the switch. You can identify the ports individually (for
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Create LACP (IEEE 802.3ad) Aggregator
1 - Aggregator ..................
2 - Adminkey .................... 0x0000
3 - Distribution Mode ........... SRC/DST MAC
4 - Port Range ..................
C - Create Aggregator
R - Return to Previous Menu
Enter your selection?