Allied Telesis AT-S63 - Manual (Page 748)

Chapter 32: PKI Certificates and SSL
748 Section VII: Management Security
Viewing or Configuring the Number of Certificates in the Database
The maximum number of certificates you can add to the certificate
database is 12 to 256. The default value is 256. There should be little
cause or need for you to adjust this value.
To view or change the number of certificates in the certificate database,
perform the following procedure:
1. From the Main Menu, type 7 to select Security and Services.
The Security Configuration menu is shown in Figure 82 on page 259.
2. From the Security Configuration menu, type 7 to select Keys/
Certificates Configuration.
The Keys/Certificates Configuration menu is shown in Figure 251 on
page 705. Selection 1, Maximum Number of Certificates, shows the
current setting.
Note
You can specify the distinguished name for the certificate from this
menu by selecting option 1, Distinguished Name, in the Keys/
Certificates Configuration menu and entering the name. Or, you can
wait and specify the distinguished name later in this procedure. For
information about distinguished names, refer to “Distinguished
Names” on page 721.
3. To change the maximum number of certificates, type 1 to select
Maximum Number of Certificates.
The following prompt is displayed:
Enter certificate limit -> [12 to 256] 256
4. Enter a new number and press Return.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.