Allied Telesis AT-S63 - Manual (Page 552)

Chapter 23: Port-based and Tagged VLANs
552 Section V: VLANs
ˆ Each port-based VLAN must be assigned a unique VID. If a particular
VLAN spans multiples switches, each part of the VLAN on the different
switches should be assigned the same VID.
ˆ A port can be an untagged member of only one port-based VLAN at a
time.
ˆ Each port must be assigned a PVID. This value must be the same for
all ports in a port-based VLAN and it must match the VLAN’s VID. This
value is automatically assigned by the AT-S63 management software.
ˆ A port-based VLAN that spans multiple switches requires a port on
each switch where the VLAN is located to function as an
interconnection between the switches where the various parts of the
VLAN reside.
ˆ If there are end nodes in different VLANs that need to communicate
with each other, a router or Layer 3 switch is required to interconnect
the VLANs.
ˆ An AT-9400 Series switch can support up to 4094 port-based VLANs.
Drawbacks of
Port-based
VLANs
There are several drawbacks to port-based VLANs:
ˆ It is not easy to share network resources, such as servers and printers,
across multiple VLANs. A router or Layer 3 switch must be added to
the network to provide a means for interconnecting the port-based
VLANs. The introduction of a router into your network could create
security issues from unauthorized access to your network.
ˆ A VLAN that spans several switches requires a port on each switch for
the interconnection of the various parts of the VLAN. For example, a
VLAN that spans three switches would require one port on each switch
to interconnect the various sections of the VLAN. In network
configurations where there are many individual VLANs that span
switches, many ports could end up being used ineffectively just to
interconnect the various VLANs.
Port-based
Example 1
Figure 195 illustrates an example of one AT-9424T/SP Gigabit Ethernet
Switch with three port-based VLANs. (For purposes of the following