Allied Telesis AT-S63 - Manual (Page 192)

Chapter 10: File System
192 Section II: Advanced Operations
Renaming a System File
To rename a system file, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown Figure 4 on page 46.
2. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 7 on page 53.
3. From the System Utilities menu, type 1 to select File Operations.
The File Operations menu is shown in Figure 56 on page 184.
4. From the File Operations menu, type 5 to select Rename File.
The following prompt is displayed:
Enter the source file name:
Note
Files with the extension UKF are encryption key pairs. These files
cannot be copied, renamed, or deleted from the file system. To
delete a key pair from the switch, refer to “Deleting an Encryption
Key” on page 709.
5. Enter the name of the file you want to rename. If the file is located on a
compact flash card, precede the filename with “cflash:”
The following prompt is displayed:
Enter the destination file name:
Note
The source and destinations be on the same device, either flash
memory or a compact flash card.
6. Enter the new name for the file.
You can enter a file name of up to 16 alphanumeric characters,
followed by a 3 letter extension. You must keep the same extension. If
the file is located on a compact flash card, precede the filename with
“cflash:”
The following message is displayed: