Operation – Barco DX-700 User Manual
Page 101
DX-700 • User’s Guide • Rev 02
101
4. Operation
Using the Input Wizard
module 2) to output 2. Output 3 has yet to be assigned. When you store a
preset at this point in the Input Wizard, it has the following attributes:
13.
Press {Save} to display the Keyboard.
Figure 4-35.
Keyboard (sample)
~
Enter a preset name up to 29 characters in length.
~
Press {Enter} to accept the name. The system confirms the preset
name, and returns you to the Save Configuration Menu. If desired, you
can save another preset (for the same current system configuration).
~
If required, press {Esc} to return to the Save Configuration Menu
without saving a preset.
Table 4-1.
Sample Preset Attributes
Bank
Selected Input
↓
... on Input Module
↓
... is assigned to Output
↓
1
DVI
1
1
RGBHV
2
2
Not Assigned
Not Assigned
3
Important
The preset’s attributes, as stored, will be applied to the bank
whenever the preset is recalled.
Tip
Because presets are “bank” specific, use a name that not only
identifies the current input that you are saving, but the state of
the entire bank and all of its outputs.