Barco DX-700 - Manual (Page 119)

DX-700 • User’s Guide • Rev 02 119
4. Operation
Using the Input Management Menu
^ЗамлнбеЦ=sáÇÉç=bÑÑÉÅíë
For the selected input, Video Effects adjustments enable you to adjust input opacity,
negative video, monochrome, freeze and strobe effects.
„
Use the following steps to adjust input video effects:
1. (Optional) If required, use the Preset Management Menu to recall a preset that
includes the input that you wish to adjust. This step activates an input. Refer to
the “
Recall a Preset ” section on page 104.
If the input is already active, no action is required in this step.
2. From the Home Menu, press {Input Management} to display the Input
Selection Menu
.
3. On any bank, select the input card (module) that includes the active input that you
wish to adjust. The Input Management Menu appears.
4. Select the Video Effects Tab (FX 1) to display video effects parameters.
Figure 4-54. Input Management Menu: Video Effects Tab (sample)
Perform the following adjustments as required:
5. Use the Alpha blending slider to adjust the opacity of the input.
6. Enable or disable the Negative Video check box to reverse the polarity of the
image.
7. Enable or disable the Monochrome check box to remove or enable the image’s
chroma information.
8. Enable or disable the Freeze On check box to freeze and un-freeze the input.
9. Enable or disable the Strobe On check box, which when enabled, acts as a
programmable freeze. Use the Strobe Slider to set the freeze interval (in
frames).
This completes the Video Effects adjustment procedure.