Barco DX-700 - Manual (Page 55)

DX-700 • User’s Guide • Rev 02 55
2. Hardware Orientation
Module Installation and Configuration
jçÇìäÉ=fåëí~дд~нбзе=~еЗ=`зеСбЦмк~нбзе
The following topics are discussed in this section:
• Module Configuration Rules
• Module Insertion and Extraction
• Storing Spare Modules
jçÇìäÉ=`зеСбЦмк~нбзе=oìäÉë
DX-700 input and output modules can be configured in a variety of ways, but important sets
of rules apply to their placement. As a prerequisite, ensure that you are familiar with the
“
Understanding Banks ” section, on page 24 in Chapter 1.
Please note the following important “module” rules:
• In the most basic of DX-700 “single bank” configurations, you must have at least
one input module and one output module — to route video to an LED wall.
• As you face the rear of the chassis, the right-most module within the entire Input /
Output Section
must always be an Output Module, and it must always be right-
justified against the System Module.
Figure 2-12. Right justification of Output Modules against the System Module
• Within any bank, all modules must be adjacent to each other — with no blank
panels in-between, and all Output Module(s) are always right-justified.
Figure 2-13. Adjacent modules within a bank
Blank Blank Blank Input Input Input
O
u
tput
Sy
s
tem
Powe
r
Inpu
t
Inpu
t
Inpu
t
Ou
tpu
t
Sy
s
te
m
Po
wer
Bl
ank
Bl
ank
Bl
ank
Correct Justification Incorrect Justification
Input / Output Section Input / Output Section
Blank Input
O
u
tput
Sy
s
tem
Powe
r
Input
O
u
tput
Blank Blank
Correct Justification Incorrect Justification
Inpu
t
Ou
tpu
t
Sy
s
te
m
Po
wer
Ou
tpu
t
Inpu
t
Bl
ank
Bl
ank
Bl
ank
Bank 1 Bank 1