Barco DX-700 - Manual (Page 137)

DX-700 • User’s Guide • Rev 02 137
4. Operation
DX-700 Management Menu Operations
~ Press {Test Patterns} to access the Test Pattern Menu, which allows
you to display test patterns for a single output or a group. Refer to the
“
Using the Test Pattern Menu ” section on page 148 for instructions.
~ Press {Monitor Setup} to display the Monitor Output Menu, which is
used to set a variety of monitor attributes. Refer to the “
Using the
Monitor Output Menu ” section on page 150 for instructions.
~ Press {EDID} to access the EDID Menu, which is used to program EDID
parameters. Refer to the “
Using the EDID Menu ” section on page 151
for instructions.
~ Press {Genlock} to display the Bank Sync Menu, which enables you to
set genlock parameters. Refer to the “
Understanding Genlock
Options ” section on page 153 for instructions.
~ Press {Expert} to display the Expert Menu, which allows users to set
delay modes, canvas orientation, and output timing.
~ Press {Save} to save system configurations to a “startup” file. Refer to
the “
Saving DX-700 Management Settings ” section on page 164 for
instructions.
Note It is recommended that you use the DX-700’s default settings
for these “Expert” options, but if you need to adjust these
parameters, refer to the “
Using the Expert Menu ” section on
page 158.