Fiberlink nni receiver, Cáäéêäáåâ=kkf=oéåéáîéê, Ak==cáäéêäáåâ=kkf=fåëí~дд~нбзе – Barco DX-700 User Manual
Page 210
210
DX-700 • User’s Guide • Rev 02
aK==cáÄÉêäáåâ=kkf=fåëí~дд~нбзе
Fiberlink NNI Hardware
cáÄÉêäáåâ=kkf=oÉÅÉáîÉê
The following figures illustrate both sides of the Fiberlink NNI Receiver:
Figure D-3.
Fiberlink NNI Receiver
Following are descriptions of all Fiberlink NNI Receiver components:
1)
Sun Shield
The Sun Shield is designed to provide thermal protection from sun-generated
overheating, within the recommended operating temperature range: -20° C to
55° C (-4° F to 131° F).
2) Power
Cable
A captive Power Cable is provided. Connect to a suitable AC power source.
3) Fiber
Connection
LED
The Fiber Connection LED indicates the status of the data coming over the fiber
optic cable from the Fiberlink NNI Transmitter. Green indicates that a signal is
present. Off indicates that a signal is not present. Refer to the “
” section on page 211 for important information about LED error
indicators.
NNI Side
Fiber Side
1
2
5
6
4
3
7
Power
NNI
FBR
8
1)
4)
NNI Connection LED
7)
2)
5)
8)
3)
6)
Power LED
Important
The Fiberlink NNI Receiver can be used in direct sunlight
when mounted vertically, as shown on page 214. Do not
prevent air from flowing around the unit. To avoid
overheating, do not leave the Receiver in direct sunlight for
prolonged periods of time.