Barco DX-700 - Manual (Page 127)

DX-700 • User’s Guide • Rev 02 127
4. Operation
Using the Display Management Menu
The figure below illustrates the Display Management Menu. The {Fiberlink}
button appears only if a Fiberlink connection has been set up.
Figure 4-61. Display Management Menu (sample)
4. Press {LED} to display the Output Display Menu.
Figure 4-62. Output Display Menu (sample)
5. To set the control unit, select either the Tile or the Creative radio button.
6. To change the tile resolution (different from the default 1:1 values as shown):
~ Select either the Real or Virtual radio button. Note that “virtual”
resolution is only supported by certain tiles. If virtual is not supported,
the button is grayed out.
~ Press the H value box, and use the keypad to enter the desired
horizontal resolution. For vertical resolution, repeat for V.