Barco DX-700 User Manual
Page 155
DX-700 • User’s Guide • Rev 02
155
4. Operation
DX-700 Management Menu Operations
4.
When Input is selected (in step 3), focus jumps to one of your input modules. To
set the input genlock source, select an input card to display the Genlock Input
Connector Selection Menu
, shown in the following illustration.
Figure 4-93.
Genlock Input Connector Selection Menu (sample)
This menu displays a graphic of the selected input module.
~
If the system detects sync for an input, its button is active.
~
If the system does not detect sync, the button is inactive.
~
If you connect an input source to the module at this point, press
{Refresh}
. The system searches for sync, and re-draws the screen with
new (updated) button status.
5.
Select the input that you want to use as the genlock source. The system
immediately locks to the selected input and returns to the Bank Sync Menu.