Changing z-order, Ь~ецбец=wjlêçéê, Operation – Barco DX-700 User Manual
Page 110
110
DX-700 • User’s Guide • Rev 02
4. Operation
Using the Input Management Menu
`Ь~еЦбеЦ=wJlêÇÉê
Z-Order is a function that assigns priorities to input modules in a bank. The higher the
priority, the further “forward” the output region appears on the canvas. The following
important rules apply:
•
Six (6) is the highest priority — visually in front of all other output regions.
•
One (1) is the lowest priority (in a configuration with six input modules) — visually
behind all other output regions in the bank.
•
Priority assignments are mutually exclusive. If you change the priority of one
module, all other modules change accordingly.
•
Priority is bank-specific. In a system with two banks, each bank will have its own
highest and lowest priority modules.
When you run the Input Wizard, Z-order is automatic, based on the configuration of the
input modules in the selected bank:
•
The right-most input module (directly adjacent to an output module) is
automatically assigned the highest priority.
•
Subsequent input modules are assigned priority sequentially, in descending order.
Figure 4-43.
Automatic Z-Order priority assignments (using a sample bank)
Use the following steps to change Z-Order:
1.
(Optional) If required, use the Preset Management Menu to recall a preset that
includes the input that you wish to adjust. This step “activates” an input. Refer to
the “
” section on page 104. If the input is already active, no action
is required in this step.
Blank
Input
Input
Input
Ou
tp
ut
Sy
s
tem
Po
we
r
Input
Canvas
Output
Region
Output
Region
Output
Region
Output
Region
4
3
2
1
Ou
tp
ut