Barco DX-700 - Manual (Page 73)

DX-700 • User’s Guide • Rev 02 73
4. Operation
Quick Function Reference
Adjust viewport settings Adjusting Viewport Settings 114
Adjust wall contrast Using the Input Wizard 93
Adjust wall contrast Managing LED 126
Adjust wall gamma Using the Input Wizard 93
Adjust wall gamma Managing LED 126
Adjust wall OSD Managing LED 126
Adjust window settings Adjusting Window Settings 112
Auto acquire the input Adjusting Viewport Settings 114
Calibrate the display Using the Front Panel Display Adjustments Menu 145
Change the canvas orientation Refreshing the Canvas Size 160
Change IP address Using the Ethernet Menu 142
Change monitor video Using the Monitor Output Menu 150
Change Z-Order Changing Z-Order 110
Check the firmware version Using the DX-700 Status Menu 138
Control the DX-700 Controlling the DX-700 76
Delay processing pre-selection Pre-selecting the Delay Mode 159
Delete a single preset Delete a Preset 106
Delete all presets Delete All Presets 106
Display a single output on the monitor Using the Monitor Output Menu 150
Display an input test pattern Adjusting Window Settings 112
Display Fiberlink properties Managing Fiberlink Settings 130
Display monitor raster box Using the Monitor Output Menu 150
Display monitor test patterns Using the Monitor Output Menu 150
Display output raster box Using the Test Pattern Menu 148
Display output test patterns Using the Test Pattern Menu 148
Display the canvas (bank) on the monitor Using the Monitor Output Menu 150
Display wall internal test patterns Managing LED 126
Enable a color key Adjusting Color Effects 120
Force display power on/off Forcing the Display 133
Freeze an input Adjusting Video Effects 119
Generate Fiberlink receiver test patterns Managing Fiberlink Settings 130
Generate Fiberlink transmitter test patterns Managing Fiberlink Settings 130
Group outputs Using the Setup Wizard 80
Table 4-1. DX-700 Quick Function Reference Table (Continued)
How to: Use the Following: Page