Barco DX-700 - Manual (Page 58)

58 DX-700 • User’s Guide • Rev 02
2. Hardware Orientation
Module Installation and Configuration
4. Raise the top latch until you can slide the module farther into the chassis — up to
the latch’s pivot point.
Figure 2-17. Latch raised, module inserted to pivot point
5. Simultaneously push both latches towards the center of the module, until the
module is fully seated against the chassis.
Figure 2-18. Latches pushed simultaneously towards center
6. Tighten both retaining screws to secure the module.
Pivot
Point
Raise latch, slide
module farther in,
until it stops
against pivot point
Caution Always push both latches simultaneously. If you use one
latch only, you can damage the module.
Simultaneously
push both latches
towards the center
of the module
CAUTION:
Always use both
latches. Damage
will result if you
use a single latch