Barco DX-700 - Manual (Page 131)

DX-700 • User’s Guide • Rev 02 131
4. Operation
Using the Display Management Menu
„
Use the following steps to manage Fiberlink settings for Barco legacy tiles:
1. From the Home Menu, press {Display Management} to display the Output
Selection Menu
.
2. Immediately above the graphic, press the button for the bank that contains the
output whose Fiberlink settings you wish to manage.
3. On the selected bank, press the output that you wish to manage. The Display
Management Menu
appears.
4. Press {Fiberlink} to display the Fiberlink Menu.
The figure below illustrates the Fiberlink Menu.
Figure 4-67. Fiberlink Menu (sample)
5. Press {Processing} to display the Fiberlink Processing Menu:
Figure 4-68. Fiberlink Processing Menu
6. To turn LED wall power on or off, enable or disable the Power On check box, as
required.