Barco DX-700 - Manual (Page 80)

80 DX-700 • User’s Guide • Rev 02
4. Operation
Using the Setup Wizard
In the rear panel graphic, the color of the output buttons mirrors that of the text:
• A Green button indicates that tiles are detected and the output is set up.
• A Red button indicates that tiles are detected, but the output is not set up.
• A Gray button indicates an output on which tiles are not detected.
• Cyan indicates “focus.”
For the Tx and Rx columns in the table, different combinations of status provide important
Fiberlink information, as shown below:
rëáåÖ=íÜÉ=pÉíìé=tбт~кЗ
The following topics are discussed in this section:
• Setup Wizard Menu Trees
• Setup Wizard Operations
• Group Color Scheme
Table 4-2. Tx and Rx status combinations
Tx Column Rx Column Description
ON ON Fiberlink NNI Transmitter is detected. Receiver is
detected. The system will list tile quantities and type —
provided that tiles are properly connected to the receiver.
ON OFF Transmitter is detected. Receiver is detected, but it is off.
The system will not list tile quantities and type.
ON – – Transmitter is detected. Receiver is not detected. The
system will not list tile quantities and type.
– – – – Transmitter is not detected. Receiver is not detected.
The system will not list tile quantities and type.
– – – – Transmitter is not detected. Receiver is not detected.
Fiberlink is not used. Instead, a direct connection is used
between DX-700 and the tiles. The system will list tile
quantities and type — provided that tiles are properly
connected to DX-700.
– – – – Transmitter is not detected. Receiver is not detected.
Fiberlink is not used. Instead, CompactLink is used, but it
is transparent to DX-700.