Barco DX-700 - Manual (Page 163)

DX-700 • User’s Guide • Rev 02 163
4. Operation
DX-700 Management Menu Operations
The figure below illustrates the Position/Active Tab.
Figure 4-101. Output Timing Menu — Position/Active Tab
10. Use the Horizontal Position slider to adjusts the offset of the start of the active
area from H sync. The adjustment is in pixels.
11. Use the Vertical Position slider to adjust the offset of the start of the active area
from V sync. The adjustment is in lines.
12. Use the Horizontal Active slider to adjust the size of the active area. The
adjustment is in pixels.
13. Use the Vertical Active slider to adjust the size of the active area. The
adjustment is in pixels.
14. To restore the default settings, press {Reset}.
15. Press {Previous} to return to the Timing Output Select Menu to set up timing for
another output group. Or, press {Previous} twice to return to the Expert Menu.
This concludes the Output Timing procedure.
Note Depending on the selected output, not all sliders are available
on the tab.