Barco DX-700 - Manual (Page 83)

DX-700 • User’s Guide • Rev 02 83
4. Operation
Using the Setup Wizard
pÉíìé=tбт~кЗ=léÉê~нбзел
The Setup Wizard steps you through the process of setting up outputs, setting up output
groups (if required), and then takes you directly to the Input Wizard to set up inputs.
The first portion of the Setup Wizard, which starts below, deals exclusively with output and
group setup. In this procedure (for each output), you will set the size of the output raster to
match the size of your LED wall.
Before you begin, be sure that all LED walls are connected to the DX-700.
„
Use the following steps to use the Setup Wizard:
1. Ensure that all your LED wall(s) are properly installed and cabled.
2. Ensure that all outputs from all output modules are properly connected to the
inputs of your wall(s).
3. On the Reduced/Minimum Delay Menu, ensure that you pre-select the desired
type of delay processing you want for a selected output: standard, reduced, or
minimum delay mode. Refer to the “
Pre-selecting the Delay Mode ” section on
page 159 for instructions on setting and changing the delay mode.
4. From the Home Menu, press {Setup Wizard} to display the Bank Selection
Menu
:
Figure 4-7. Setup Wizard: Bank Selection Menu (sample)
5. Directly above the rear-panel graphic, press the button for the bank whose
outputs you wish to set up.
Important This step is critical. Once you enter the Setup Wizard, all
LED walls that you wish to set up must be connected to the
various DX-700 outputs. If you forget to set up an output and
you opt to set it up after concluding the wizard, you will be
required to set up all walls again after you re-enter the wizard.