Barco DX-700 - Manual (Page 118)

118 DX-700 • User’s Guide • Rev 02
4. Operation
Using the Input Management Menu
3. Use the Luma Tracking slider to adjust luma tracking. Luma Tracking prevents
green haze from appearing in regions of low light.
This completes the Image Processing adjustment procedure.
^ЗамлнбеЦ=fåéìí=_~д~еЕЙ
For the selected input, Input Balance adjustments enable you to fine tune the individual
RGB brightness and contrast values, as opposed to the brightness and contrast
adjustments on the Image Processing Menu — which adjust RGB values simultaneously.
„
Use the following steps to adjust input balance parameters:
1. (Optional) If required, use the Preset Management Menu to recall a preset that
includes the input that you wish to adjust. This step “activates” an input. Refer to
the “
Recall a Preset ” section on page 104. If the input is already active, no action
is required in this step.
2. From the Home Menu, press {Input Management} to display the Input
Selection Menu
.
3. On any bank, select the input card (module) that includes the active input that you
wish to adjust. The Input Management Menu appears.
4. Select the Input Balance Tab (I.B.) to display all parameters for input balance.
Figure 4-53. Input Management Menu: Input Balance Tab (sample)
Perform the following adjustments as required:
5. In the Brightness section, use the individual RGB sliders to adjust the brightness
of the selected input.
6. In the Contrast section, use the individual RGB sliders to adjust the contrast of
the selected input.
This completes the Input Balance adjustment procedure.