Barco DX-700 - Manual (Page 195)

DX-700 • User’s Guide • Rev 02 195
_K==oÉãçíÉ=`зенкзд=mêçíçÅçä
DX-700 Remote Command List
S
Example: FIBERRXPWR? | 2 | 1 | 1
1 | 0 | 1
cf_bohbvobc
• Description : Set Fiberlink Key Reference.
• Set format : FIBERKEYREF | Bank | Out | Index | Mode
• Parameters :
~ Bank: Bank ID 1 – 3
~ Out: Output ID 1 – 6
~ Index: Fiberlink index (starts from 1, use 0 for all Fiberlinks Rx)
~ Mode: Key Reference mode [ 0 | 1 ] .. 0 = Synthesized, 1 = Transmitted
S
Example: FIBERKEYREF | 1 | 3 | 0 | 1
• Query format : FIBERKEYREF? | Bank | Out | Index
• Query returns : Mode | Min | Max
~ Mode: Key Reference mode
~ MinMode: minimum key reference mode
~ MaxMode: maximum key reference mode
S
Example: FIBERKEYREF? | 2 | 1 | 1
1 | 0 | 1
cf_bocfiqbo
• Description : Set Fiberlink Reconstruction Filter.
• Set format : FIBERFILTER | Bank | Out | Index | H | V | DE
• Parameters :
~ Bank: Bank ID 1 – 3
~ Out: Output ID 1 – 6
~ Index: Fiberlink index (starts from 1, use 0 for all Fiberlinks Rx)
Important Be advised that in displays with multiple Fiberlinks, turning on
the power using broadcast will not give the same result as
turning off the power. In situation when all of the power is off,
broadcasting the "power on" command will only turn on the
link that is connected directly to the digitizer — up to the next
Fiberlink. This occurs because if the next Fiberlink's LED
power switch is still off, the broadcast command won't be able
to pass through it.
Note This command valid for Fiberlink Version 1 only.
Note This command valid for Fiberlink Version 1 only.