Barco DX-700 - Manual (Page 212)

212 DX-700 • User’s Guide • Rev 02
aK==cáÄÉêäáåâ=kkf=fåëí~дд~нбзе
Installation
„
To rectify the error:
1. Remove power to the Fiberlink NNI Receiver by disconnecting its AC line cord.
2. Troubleshoot the tile array, and determine the cause of the power supply problem
or the connection-related error — the one that is causing the Fiberlink NNI
Receiver
to draw excessive current.
3. Once the tile problem has been determined and solved, re-connect power to the
Fiberlink NNI Receiver, and note the status of the LEDs.
~ If the LEDs light green and do not blink, the problem has been solved.
~ If the LEDs again start to blink (either fast or slow), repeat this
troubleshooting procedure from step (1).
fåëí~дд~нбзе
The following topics are discussed in this section:
• Unpacking and Inspection
• Site Preparation
• Cable and Adapter Information
• Securing the Dust Cap on the Fiber Optic Cable
• Installing the Fiberlink NNI Modules
• Signal Connection
rей~ЕвбеЦ=~еЗ=fåëéÉÅíáçå=
Before opening the boxes, inspect them for damage. If you find any damage, notify the
shipping carrier immediately for all claims. As you open the box, compare its contents
against the packing slip. If you find any shortages, contact your sales representative.
Once you have removed all the components from their packaging and checked that all the
components are present, visually inspect each unit to ensure there was no damage during
shipping. If there is damage, notify the shipping carrier immediately for all claims.
páíÉ=mêÉé~к~нбзе=
The environment in which you install your Fiberlink NNI units should be clean, properly lit,
free from static electricity, and have adequate power, ventilation, and space for all
components.