Barco DX-700 - Manual (Page 85)

DX-700 • User’s Guide • Rev 02 85
4. Operation
Using the Setup Wizard
At the top of the Output Selection Menu, the output table lists current system
information. Refer to the “
Output Table Description ” section on page 79 for a
description of the data. Below the table is the rear panel graphic. Please note:
~ Each output is a button.
~ Color is significant:
• Red indicates “tiles detected,” but the output is not set up.
• Green indicates the output is set up.
• Gray indicates “tiles not detected.”
• Cyan indicates “focus.”
7. Press the button for the output that you wish to set up.
8. Depending on the type of output module(s), the following options are available:
~ For a bank that uses NNI output modules, the Test Pattern Rolling
prompt appears. Please continue with step
14 .
~ For a bank that uses DVI output modules, the Wall Positioning Menu
appears. Please continue with step
9 below.
9. For tiles connected to DVI output modules, the Wall Positioning Menu enables
you to set dimensions, direction, and the starting point. The number of “detected”
tiles is shown. The figure below shows the Set Dimensions Section of the menu.
Figure 4-10. Wall Positioning Menu: Set Dimensions Section (sample)
~ Press {Set Columns}, and use the keypad to enter the number of
columns in the wall. The Set Start Section of the menu updates.
~ Press {Set Rows}, and use the keypad to enter the number of rows in
the wall. Both the Set Direction and Set Start sections update.
10. In the Set Direction Section, press the button for the direction in which your tiles
are wired — either {Horizontal} or {Vertical}.
Figure 4-11. Wall Positioning Menu: Set Direction Section (sample)
Note If you press a gray button for an output in which tiles have not
been detected, the system provides a series of intelligent
troubleshooting tests for power, cables and Fiberlink
connections.