Barco DX-700 - Manual (Page 86)

86 DX-700 • User’s Guide • Rev 02
4. Operation
Using the Setup Wizard
11. In the Set Start Section, press the button for the point at which your wiring starts
— either {Top Left}, {Bottom Left}, {Top Right}, or {Bottom Right}.
Figure 4-12. Wall Positioning Menu: Set Start Section (sample)
12. Press {Apply}.
~ If all parameters have been properly set, the {Next} button appears.
~ If the system detects a mismatch between the number of tiles detected
and the number entered, a pop-up message appears. You will need to
start the procedure again from step
9 .
13. Press {Next}.
14. The Test Pattern Rolling prompt appears.
Figure 4-13. Test Pattern Rolling Prompt
~ Press {Yes} if the test pattern is rolling smoothly. The Output Position
Menu
is displayed. Please continue with step 15 .
~ Press {No} if the test pattern is not rolling smoothly:
• For DVI tiles, the system remains on the Wall Positioning
Menu
, enabling you to re-enter correct tile information.
• For NNI tiles, you will be asked to check all cabling, and then
click the {Detect} button.
Figure 4-14. Detect function for NNI tiles
After clicking {Detect}, the system returns to the Output
Selection Menu
at the beginning of the wizard.