Barco DX-700 - Manual (Page 114)

114 DX-700 • User’s Guide • Rev 02
4. Operation
Using the Input Management Menu
^ЗамлнбеЦ=sáÉïéçêí=pÉííáåÖë
For the selected input, Viewport Setting adjustments enable you to select (or “isolate”) a
portion
of the input source to fit within the selected output region. Here, you are essentially
sizing and positioning the input. Note that this adjustment is the same as the one
performed on the Viewport Adjust Menu in the Input Wizard.
„
Use the following steps to adjust viewport settings:
1. (Optional) If required, use the Preset Management Menu to recall a preset that
includes the input that you wish to adjust. This step “activates” an input. Refer to
the “
Recall a Preset ” section on page 104.
If the input is already active, no action is required in this step.
2. From the Home Menu, press {Input Management}.
3. On any bank, select the input module that includes the active input that you wish
to adjust. The Input Management Menu appears.
4. Select the Viewport Settings (V.S.) Tab.
Figure 4-48. Input Management Menu: Viewport Settings Tab (sample)
Perform the following adjustments as required:
5. In the Color Space section, select either RGB or YUV color space.
6. Use the following controls to select (or “isolate”) a portion of the input source to fit
within the selected output region. All adjustments are in pixels.
~ Use the Viewport Left slider to adjust the input’s horizontal position.
~ Use the Viewport Top slider to adjust the input’s vertical position.
~ Use the Viewport Width slider to adjust horizontal size.
~ Use the Viewport Height slider to adjust the input’s vertical size.
7. Press {Auto Acquire Input} to re-acquire the input, if for example, the input was
lost, if you changed inputs, or if the image does not appear correct.
This completes the Viewport Settings adjustment procedure.