Barco DX-700 - Manual (Page 214)

214 DX-700 • User’s Guide • Rev 02
aK==cáÄÉêäáåâ=kkf=fåëí~дд~нбзе
Installation
fåëí~ддбеЦ=нЬЙ=cáÄÉêäáåâ=kkf=jçÇìäÉë
The Fiberlink NNI units can be mounted in different ways, depending on your specific site
requirements. Using the 8mm mounting holes provided in the unit’s Sun Shield, you can
secure the modules with tie wraps or mounting screws as required. Please note:
• If you lay the units flat on the ground, do not immerse them in water or allow them
to sit in puddles of water.
• If you mount the units to a wall, frame, rack, or other solid structure, please
observe the following recommendations:
~ Mount the units vertically, not horizontally.
~ Ensure that the status LEDs on the NNI side of the modules are visible.
Figure D-5. Fiberlink NNI module vertical mounting
páÖå~д=`зееЙЕнбзе
This section provides instructions for connecting signals to the Fiberlink NNI modules.
„
Use the following steps to connect signals to the Fiberlink NNI modules:
1. Ensure that the LED wall is properly set up and cabled for data and power, and
that the tiles are Barco NNI LED tiles.
2. Ensure that the DX-700 is properly set up to communicate with the NNI LED wall.
3. Ensure that the Fiberlink NNI Transmitter is located within 3m of the DX-700.
4. Ensure that the Fiberlink NNI Receiver is located within 3m of the NNI LED wall.
5. Ensure that the fiber optic cable is properly run between the Fiberlink NNI
Transmitter
and Fiberlink NNI Receiver, and that all fiber optic cable
maintenance procedures are strictly followed. Refer to the “ Proper Fiber Optic
Cable Maintenance ” section on page 216 for details.
6. Connect the supplied NNI cable from the DX-700 to the NNI Connector on the
Fiberlink NNI Transmitter.
NNI Side
(Status LEDs)
Fiber Side
Warning The HDMI-type connectors on the DX-700 NNI output
module and the DX-700 modules use proprietary signals
and pinouts.
Do not connect the output of an NNI output module to
anything other than the input of a Barco NNI LED tile (i.e.,
NX-4 and NX-6) or a Fiberlink NNI Transmitter or Receiver.
Even though the connector is an HDMI-type connector, it is
not an HDMI signal, and serious damage could result if, for
example, the output is plugged into an HDMI monitor.