Setting the master sync source, Péííáåö=íüé=j~лнйк=póåå=pçìêåé – Barco DX-700 User Manual
Page 156
156
DX-700 • User’s Guide • Rev 02
4. Operation
DX-700 Management Menu Operations
6.
To sync an output to the input connector, select the desired output. The Output
Refresh Rate Menu
appears.
Figure 4-94.
Output Refresh Rate Menu (sample)
~
Select {System refresh rate} to lock the output or the group signal to the
bank’s refresh rate.
~
Select {Independent refresh rate}, then select the Frame Rate box.
When the Keypad appears, enter a new rate. The output or group is no
longer locked to the bank’s refresh rate.
7.
Press {Previous} to return to the Bank Sync Menu.
pÉííáåÖ=íÜÉ=j~лнЙк=póåÅ=pçìêÅÉ
The Master Sync Menu enables you to perform the following functions:
•
Lock the entire system to a single sync source.
•
Lock outputs in different banks to the same sync source. To do so, set the master
sync source using the Master Sync Menu, then go to the Bank Sync Menu and
lock individual outputs in one or more banks to the master sync source.
The master sync source can be an external signal, the signal for a specified input, or can
be set to freerun at a specified rate.
Use the following procedure to set the master sync source.
1.
From the Home Menu, press {DX-700 Management}.
2.
Press {Genlock} to display the Bank Sync Menu.
3.
Press {Master} to display the Master Sync Menu.
This menu is similar to the Bank Sync Menu, but in the Sync Source section, the
Master Genlock
button has changed to Ext Genlock. In the lower graphic
section, the Genlock connector on the System Module is an available button.